Total Pageviews

Safety Lessons

Search results


Safety Blogs

Featured post

Occupational Dermatitis Hazards and Control Measures

Prevent Occupational Disease - Hazards and Control Measures Occupational skin diseases, including occupational dermatitis, are the s...

Popular Blogs

Tuesday, 10 July 2018

6 Situations That Can Tip a Forklift—And How to Control Them

6 Situations That Can Tip a Forklift—And How to Control Them

Topic: Forklifts

Prevent deadly forklift tipover accidents by ensuring operators are properly trained to recognize hazardous situations and circumstances.
Antonio Toro was preparing to move large bundles of steel at a flood control project. As he positioned his forklift, it tipped, pinning him. By the time emergency responders reached him, Toro was dead.
Forklifts are designed to lift and move heavy loads. The forklifts themselves must be heavy to prevent them from falling forward when the load is lifted. Forklifts also tend to be small and narrow to navigate tight workspaces.
Being small, narrow, and heavier than they look can be a recipe for tipping if workers are not careful.
Tipover accidents are more likely in certain situations and circumstances. Make sure your workers know their specific truck, terrain, and load, and take precautions to prevent tipovers.

1. Inadequately Secured Loads

A load that is not secured can shift, tipping the lift. Workers must know:
  • Not to move the truck until the load is secure. The load-engaging device must be placed in a manner that securely holds or supports the load.
  • Not to tilt the load-engaging means forward while the forks are elevated, unless they are picking up a load. An elevated load also must not be tilted forward unless it’s being deposited.
  • How to use attachments. If the truck is equipped with attachments, special precautions may be required for securing loads and for operating the truck after the load has been removed.

2. Overloaded Forklifts

Loading a forklift beyond its rated capacity can cause the lift to tip. Make sure workers never exceed the forklift’s rated capacity. The rated capacity of all industrial forklifts must be prominently displayed on the vehicle at all times, in a location where the operator can easily see it.
Besides observing the forklift’s rated capacity, operators should heed the rated capacity of the work surface (floor, ramp, dockplate, or other operating surface).

3. Poorly Selected Forklifts

Using the wrong truck for the terrain can cause a lift to tip. Make sure workers know not to use a forklift designed for use on smooth concrete in areas with rough terrain.

4. Traveling or Parking on a Grade

A forklift is more likely to tip on a grade than on a flat surface. Make sure workers know that:
  • On grades greater than 10 percent, loaded trucks must be driven with the load upgrade, except for motorized hand and hand/rider trucks, which should be operated on all grades with the load downgrade.
  • On all grades, they should raise the load only as far as necessary to clear the road surface and should tilt the load-engaging means back if possible.
  • They should avoid turning on a grade.

5. Alterations to the Forklift

Alterations to a forklift can change the lift’s capacity and handling characteristics, including its susceptibility to tipover. Make sure workers know that no alterations may be made to a truck that will:
  • Change the relative positions of the various parts from the manufacturer’s original positions;
  • Add parts not provided by the manufacturer;
  • Eliminate parts provided by the manufacturer; or
  • Add counter weighting, unless approved by the manufacturer.

6. Poorly Marked Aisles

Forklifts often tip or roll over the side of a ramp, dock plate, or loading dock.
Make sure markings are present and clearly visible at edges of loading docks and other areas where forklifts could roll off, along with other precautions such as guardrails and chains.
Operators must also take special care when moving from bright to dim light, which can blind them just long enough for them to miss visual cues.

No comments:

Post a comment